IF YOUR HOT WATER SYSTEM SUDDENLY CEASES WORKING: HOW TO DO

If Your Hot Water System Suddenly Ceases Working: How to Do

If Your Hot Water System Suddenly Ceases Working: How to Do

Blog Article

Learn More

How do you feel in regards to What Would Cause My Electric Water Heater to Stop Working??


No Hot Water — Water Heater Repair
Numerous contemporary houses take advantage of an electrical hot water heater for their heating unit, due to its comfort as well as simplicity of use. However, similar to any other electric devices, problems may emerge with its use, unexpectedly. It can be actually frustrating to awaken to a cold shower instead of a hot one or having your bathroom with water that isn't warm adequate and even also hot. Whatever the instance may be, water heater issues can be quite aggravating. Luckily, we have actually made a list of possible options to your hot water heater problems. There are a number of variables that might cause most of these troubles, maybe a problem with the power supply, the electric heating element, or the thermostat. Before doing anything, guarantee you turn off the main power supply for safety. Whatever the problem is, getting it dealt with must not pose way too much of an issue if you follow these steps:

Check Your Power Supply:


As fundamental as this may seem, it is very required. Without sufficient power, your hot water heater will certainly not operate. So the first thing to do when your water unexpectedly stops working is to verify that it isn't a power trouble. Examine if the fuse is burnt out or the breaker tripped. If the breaker is the concern, simply turn it off and on once again. Replace any type of damaged or worn-out fuse. Check the home appliance with power after these modifications to see if it's currently working.

Check the Burner in the Water Heater:


If it's not a power issue, then try looking into your burner if it is still functioning. Test each of your heating elements to ensure the issue isn't with any one of them. If any of them is defective, replace that part and then check whether the warm water is back on.

Examine Your Thermostat:


If your water heater still isn't working or the water appearing isn't warm enough, you may require to inspect the temperature level settings on your top thermostat. Guarantee the breaker is switched off before doing anything. Open the access panel and also press the red switch for temperature reset above the thermostat. This must aid warm the water. Turn the circuit breaker back on as well as check if the problem has been settled.

Call A Professional:


If after replacing all damaged components as well as resetting your temperature, the water heater still isn't functioning, you might require to call an expert plumber for a specialist viewpoint. The problem with your heater could be that the hot and cold faucets have been switched over or it may be undersized for the amount of hot water required in your home. Whatever the case might be, a specialist plumber would aid address the issue.

Verdict


Water heater issues are not always major. Much of them are because of small concerns like a blown fuse or worn-out heating element. Changing the defective components must suffice. Nonetheless, if you are still incapable to solve the trouble, give a call to your nearby plumber to come to get it dealt with.

8 possible reasons why you have no Hot Water


Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.


Water Leak


Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.



Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.


Gas Heater: Gas Leak


If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.


Gas Heater: Pilot Light Problems


There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.



Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.


Gas Heater: Faulty Thermocouple


The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.


Electric Heater: Breaker Blues


Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.


Electric Heater: Reaching The Limit


If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.


Electric Heater: Heating Element


If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/


How to Troubleshoot and Repair an Electric Water Heater

As a passionate person who reads on No Hot Water — Water Heater Repair, I think sharing that editorial was a smart idea. Make sure you take the time to distribute this entry if you appreciated it. Thanks for taking the time to read it.


Emergency plumber? One call away.

Report this page